Tagged ‘bow’

Cute Cat Hair Bow

Monday, September 12th, 2011

20110911-DSC_7679
Now my hair is finally getting long I can start making pretty accessories for it. These are super simple to make and you only need a little scrap of fabric. You can experiment too with layers of fabric or using lace instead of ribbon.

I didn’t realise until reviewing the photos that black fabric isn’t a good colour to use in a tutorial as you can’t see all the stitches! Hopefully my descriptions make sense, if not, ask away and I’ll try to explain or retake the photos using lighter fabric.

Here’s what you’ll need:
20110911-DSC_7661
Fabric, coordinating ribbon, needle and thread, a hair clip and a hot glue gun.

Measure a piece of fabric that is as long as you want the bow to be x2 and then add half an inch for the overlap. The same goes for the width; twice what you want the bow to be, plus half an inch. I used a piece 8.5 inches long by 4 inches.

Sew lengthways into a tube, right sides together. Turn it inside-out and press it with an iron. Have the seam running along the centre rather than at one of the edges.
20110911-DSC_7663 20110911-DSC_7664

With the seam on the inside, fold each end of the tube into the centre, overlapping the ends by half an inch.
20110911-DSC_7667

Stitch loose stitches across the centre, through all the layers, and pull to scrunch the middle of the bow together. Secure with a few stitches.
20110911-DSC_7669

Take a piece of ribbon and starting at the centre of the bow, lay it out to the edge and fold back towards the centre. Fold it again where it reaches the other side of the bow and repeat so you have two loops of ribbon on each side like mini-bows.
20110911-DSC_7670

Stitch the ribbon in place.
20110911-DSC_7671

With the glue gun, attach the centre of the bow to the hair clip. Then take another piece of ribbon and glue the end to the inside of the clip (you may need to remove the springy bit to do this, it just pops out).
20110911-DSC_7672

Wrap the ribbon as tight as you can around the centre of the bow and the hair clip twice and then glue the end down and trim off.
Glue the bow ribbons in place on the ends of the hair clip to maintain their position and to hide all of the metal of the clip.
20110911-DSC_7673

Voila!
20110911-DSC_7676